Select an area on the back of your upper arm where the sensor will be applied. Clean this area with a sanitizing wipe and allow it to dry completely before proceeding.

Peel the lid completely off the sensor pack, and then unscrew the cap from sensor applicator. At this point, the sensor pack and applicator are ready to be assembled.

Place the sensor pack on a flat, stable surface and secure it with one hand to prevent unnecessary movement during assemble. Line up the sensor applicator with sensor pack, then press down firmly on the sensor applicator until it comes to a stop. Lift the applicator out of the sensor pack.

Remove the clip on the applicator and place the applicator on the prepared area where the sensor will be worn.

Apply the CKM system onto your arm with single-click. Slowly pull sensor applicator away from the arm and make sure that the sensor is firmly attached.

Open the SiBio CKM APP and follow the instructions to pair it with your sensor. You can either scan the QR code on the box or manually enter the 8-digit code.